Home / RevitMep / Understanding Parameters Revit mep

Understanding Parameters Revit mep

Parameters for piping are similar to the parameters for air systems such as Flow Factor, Calculated, Preset, Flow Direction, and so on. The available pipe system types are as follows:
Hydronic Supply This pipe system can also be used for chilled water supply, cold water supply, steam, hot water supply, and process piping supply.
Hydronic Return This pipe system can also be used for chilled water return, cold water return, steam condensate, hot water return, and process piping return.
Sanitary This pipe system can also be used for grease waste, oil waste, storm drainage, acid waste, contamination drainage, and condensate drainage.
Domestic Hot Water This pipe system can also be used for different hot water systems such as 140-degree, 110-degree, and tempered water.
Domestic Cold Water This pipe system can also be used for filtered water, deionized water, and chilled water for remote drinking fountains.
Other This pipe system can be one of the most utilized pipe systems if you have a large piping project. This can be used for medical gas piping, vent piping, liquid propane piping, natural gas piping, and air piping.
Fire Protection This can be used for the building sprinkler piping, or it can used for the utility fire protection coming into your building to connect the base of your fire-protection riser.
Wet Fire Protection This pipe system type normally is used for the layout of the piping from the riser to the sprinkler head layout.
Dry Fire Protection This pipe system is used for layout from the fire riser to the sprinkler head or standpipe to keep the system from freezing.
Pre-Action This pipe system can also be used for a deluge system.
Fire Protection Other This pipe system can be used for glycol antifreeze systems and for chemical suppression systems

Leave a Reply

Your email address will not be published. Required fields are marked *