Home / Tag Archives: siemens NX solution (page 5)

Tag Archives: siemens NX solution

Patch Openings siemens NX

Use the Patch Openings command to create sheet bodies to close openings in a set of faces. You can: Patch an opening using a single patch type or a sequence of patch types. Create special surfacing to patch joggles. Patch one part of a larger opening, such as in a …

Read More »

Four Point Surface siemens NX

Use the Four Point Surface command to create a surface by specifying four points. This is useful for creating base surfaces that support the surface based Class-A workflow. You can easily modify such a surface by increasing the degree and patch into a more complex surface with the desired shape. …

Read More »

Soft Blend siemens NX

Use the Soft Blend command to create tangent and curvature continuous blend faces between selected sets of faces. You can do the following: Make blends with better aesthetics than other blends as the cross section is not circular. Control the cross sectional shape. Create designs with lower weight. Create designs …

Read More »

Offset Face siemens NX

Use the Offset Face command to offset one or more faces along the face normals. You can offset faces either by positive or negative distances, provided the topology of the body does not change. You can add a single Offset Face feature to multiple bodies. Note The Thicken command is …

Read More »

Thicken siemens NX

Use the Thicken command to offset one or more connected faces or sheets into a solid body. Thickening occurs by offsetting the selected faces along their face normals, and then creating sidewalls. Note The Thicken command is similar to the Offset Face command. You can use the Boolean options with …

Read More »

Point Set to Point Set Alignment siemens NX

Use Point Set to Point Set Alignment to select any geometric object, transform it, and realign it using point sets. To do this, you need to specify a minimum of three source points (the from points) on the object you want to realign and three reference points (the to points) …

Read More »

Split Body siemens NX

Use the Split Body command to split a solid body or sheet body into multiple bodies using a set of faces or a datum plane. You can also create a sketch internal to the command and either extrude or revolve it to create the splitting tool. This command creates an …

Read More »

Patch siemens NX

Use the Patch command to modify a solid body or a sheet body by replacing faces with the faces of another sheet. In this example, the large blue sheet body is the target and the small green sheet body is the tool. Where do I find it? Application Modeling, Shape …

Read More »

Intersect siemens NX

You can intersect solids with solids, sheets with sheets, and a sheet with a solid. If you select a sheet body as a tool body, the result is a fully parameterized Intersect feature with all regions kept. If the tool body completely splits the target body into multiple solid bodies …

Read More »

Promote Body siemens NX

Use the Promote Body command to promote a body from a loaded assembly component to the level of the assembly. You do not need write access to the part containing the original, or the base body, in order to promote it. This can be especially important when working in a …

Read More »