Home / Siemens NX / Rearranging the Tool Path Order siemens NX

Rearranging the Tool Path Order siemens NX

The ability to rearrange the tool path order in an interactive fashion during synchronization gives you enormous capacity for optimizing your NC program. This is where the fine-tuning of the program occurs.

When you rearrange the order of the operations, remember that:

  • You can only rearrange in the collapsed mode.

  • You must rearrange the order before creating synchronization or dwell events.

  • You can only drag and drop an entry to a position in the same channel.

  • You cannot change the order of operations on a spindle. You must do this in the Program Order view of the Operation Navigator.

Leave a Reply

Your email address will not be published. Required fields are marked *