Use the third page of the Last Identification Wizard to select the points on the last. The graphic on the wizard will help you identify the correct point on your model.
- Select the following points on the last:
- Inner girth point
- Outer girth point
- Centre girth point
- Toe point
- Cone point.
- Vamp point
- Heal top point.
- Heel bottom point.
- Click User Defined Points to create additional points on the last. The User Defined Points dialog is displayed.
- Click one of the following buttons:
- Back displays the Curves on the last page.
- Next displays the Alignment of the last page.
- Finish creates the last.
- Cancel finishes the Last Identification Wizard without making any changes.
