Home / RevitMep / Placing Fittings Revit mep

Placing Fittings Revit mep

When you need to add valves to your piping, select the Home tab and then select Pipe Accessories. Use the Type Selector to select the type of valve you want to use. Most valves are break intotypes, so you can place them into a pipe run, and they will break into the piping, maintaining connections at either end (see Figure 11.21).

csg1
For most logical family categories, you can set this break intofunctionality in the Family Editor, choose Home Properties Family Category And Parameters (see Figure 11.22)

csg2

Leave a Reply

Your email address will not be published. Required fields are marked *