TABLE OF CONTENT
Getting Started …………………………………………………………………………………………….. 1
Tutorial #1 – Open Contour and Drill Toolpaths ……………………………………………………………………… .. 11
Tutorial #2 – Facing, Pocket, Contour, Drilling and Contour-Chamfer Toolpaths…………………………… 59
Tutorial #3 – Open Pocket, Contour Remachining, Circle Mill, Drill and Contour Toolpaths………….. 133
Tutorial #4 – 2D HS Core Mill, 2D HS Dynamic Core Mill, Pocket Island Facing and Pocket
……………………………………………….
Objectives:
1. The Student will learn about the Graphical User Interface.
2. The Student will learn how to navigate through Mastercam.
3. How to use the Status Bar to set the attributes.
4. Set the Toolbar States.
5. Setting the Grid.
LINKDOWN
http://www.mediafire.com/download/szjhdfj77dmze5m/Mastercam-X6-Mill-Level-1-Tutorial-1.pdf
Related posts:
Mastercam V9- mill level 3
Mastercam X4- hanbook volume 1- mill lever 1 &solid
Mastercam x5- drill, pocket, contour
Mastercam- introduction to Multiaxis Toolpaths
Stock Setup tab – Mill/Router Mastercam
Mastercam x6- Dynamic Milling
How-to: Setting up a job in Mastercam Mill-Turn
Dragging and dropping toolpath geometry