Home / Autodesk Inventor Help / Make sketch symmetrical about bisector autodesk inventor

Make sketch symmetrical about bisector autodesk inventor

ho6

Locate the midplane by sketching a line from the midpoint of one side to the midpoint of the opposite side. To begin, use commands on the Sketch tab to create sketch geometry. In an active sketch:

  1. Click Sketch tab  Create Panel  Line , then right-click and click Midpoint.
  2. Click a line to locate the midpoint and constrain the line to it.
  3. Right-click again and click Midpoint, then click a line on the opposite side of the sketch.

Because the line is constrained to the midpoints, it stays in the center of the sketch if it changes size.

Leave a Reply

Your email address will not be published. Required fields are marked *