Use the Last Editing dialog to assign values and select options associated with the different parameters of a last.
- Enter the values for the following parameters. Alternatively, use the up and down arrows to set the value.
- Stick length to specify the length of the last, measured using projection on the ground.
- Toe Spring to specify the height of the point from the ground.
- Insole length to specify the length of the last measured along the bottom surface.
- Heel height to specify the height of the heel bottom point from the ground.
- Girth to specify the perimeter of the cross-section taken at the girth plane.
- Use the following buttons to display the options associated with the different last parameters:
The graphic in the dialog changes to reflect the parameter you have selected.
- Select Undo the previous operation in the last editing form. Click Redoto cancel the last Undo.
- Use Restore to reset values to the original settings for the Last Editing dialog for the model.
- Click OK to accept the changes and close the dialog.