Home / Documents (page 4)

Documents

Mastercam x9- instructor- guides- metric

Table of content Lesson #1 – Introduction to CNC and Mastercam ………………………1 Lesson #2 – Introduction To Geometry Creation ……………………13 Lesson #3 – Demonstrate Break Join And Offset Exercises ………..31 Lesson #4 – Create Arc Polar, Translate And Rotate…………………..39 Lesson #5 – Create Arc Tangent, Line Tangent And Polygon ……….47 …

Read More »

Mastercam x9- hanbook volume 3 multiaxis & machining

  This chapter introduces the basic concepts and principles of multiaxis machining. Upon completion of this chapter, you should be able to do the following: INTRODUCTION There are many different Multiaxis machine tool configurations. Most control three linear (XYZ) plus two rotational axes. The rotational axes are some combination of …

Read More »

Mastercam x8 for SolidWorks

LESSON 2 – CONTOUR TOOLPATHS – PART 1 INTRODUCTION: This lesson will introduce the basic procedures for generatig a toolpath with Mastercam for SolidWorks. The toolpath will consist of simple open contours. The main goals of this lesson are to introduce you to the procedures that will be followed to …

Read More »

Mastercam x7- mill level 1 training

Table of content Getting Started…………………………1 Tutorials: Tutorial #1 – Contour, Drill Toolpath……………15 Tutorial #2 – Facing, Circle Mill, Contour, Spot Drill, Drill, Chamfer Toolpaths ………..67 Tutorial #3 – Slot Mill, 2D HS Dynamic Core, Contour, 2D HS Dynamic Contour, Facing Toolpaths…..153 Tutorial #4 – 2D HS Core, 2D HS Dynamic …

Read More »

Mastercam X9- Router professional courseware

One part of table of content 2D GEOMETRY Objectives:  Gain knowledge of Mastercam’s user interface for ease of navigation.  Create Point Positions.  Create Rectangles.  Create Lines.  Create Fillets.  Learn when and where to utilize the Trim commands.  Create Arcs.  Create Arcs Polar. Learn when and where to utilize the Xform …

Read More »

Mastercam x9- Multiaxis professional courseware

4 Axis toolpaths objectives Using Axis Substitution and rolled geometry. Using Axis Substitution and un- rolled geometry.  Using Roll Die C-hook to machine the walls with the side of the tool. Using Rotary Axis Positioning and Transform – Rotate.  Creating a Cylindrical Helix.  Creating a Conical Helix.  Using Tool Planes …

Read More »

Mastercam x7- Lathe training tutorial

table of content Tutorials Tutorial #1 – Face, Roughing & Finish Toolpaths ………………………..15 Tutorial #2 – Groove – Multiple Chains & Drilling Toolpaths……………….57 Tutorial #3 – Canned Rough & Finish, Groove At An Angle, Custom Tool & Cutoff Toolpaths…………115 Tutorial #4 – ID Rough, Finisg & Groove Toolpaths …………………………………189 Tutorial …

Read More »