ShoeMaker

It is possible to take the average (mean) of each of the following elements of the flattened halves of the last (both inside and outside): Heel curve

Use this dialog to specify the options for flattening an unflattened last. Select one of the following as the Last type: Normal. Boot. Use the slider to specify the Average piece thickness.The corresponding value is displayed. Alternatively, enter a value; the slider is adjusted to reflect the value you entered. …

Use this dialog to change the heel height by bending the portion of the last behind the girth plane. Use the Heel seat length slider to move a semi-transparent plane to change the portion between this plane and the girth plane. Moving the slider to change the heel seat length …

Currently, there are no options available for the Insole Length.

Choose a Toe Spring option to specify the method used to bend the last. Select one of the following options: From vamp to bend the front portion of the last from a plane parallel to the girth plane and passing through the vamp point. From girth to bend the front …

 Use the Stick length options to specify the parameters that are modified when you change the stick length.

Use the Last Editing dialog to assign values and select options associated with the different parameters of a last. Enter the values for the following parameters. Alternatively, use the up and down arrows to set the value. Stick length to specify the length of the last, measured using projection on …

Use the final page of the Last Identification Wizard to add additional information to the last. Specify the Type by selecting Left or Right shoe. Select the sizing Standard from the drop-down list. The standard is defined in the PSSHOESIZE_xx.csv file, where xx is the name of the standard. This …

Use the fourth page of the Last Identification Wizard to adjust the alignment of the last. The original alignment of the last is displayed as wireframe. Entering new values or using the sliders to make adjustments, modifies the model. Use the slider to Swivel the last across its length, as …

Use the third page of the Last Identification Wizard to select the points on the last. The graphic on the wizard will help you identify the correct point on your model. Select the following points on the last: Inner girth point Outer girth point Centre girth point Toe point Cone …