Home / Autodesk Inventor Help / Create bend in 3D line

Create bend in 3D line

ra11

  1. In the dialog box, set the bend radius.
  2. The Equal command is automatically selected and constrains bends to each other. If desired, cancel the selection to prevent automatically constrained bends.
  3. Select 3D lines, 3D sketch points, or included geometry (geometry copied to the 3D sketch with the Include Geometry command) that meet in a corner.
  4. Continue to select lines, then close the dialog box when finished.

When you open the Bend dialog box, the last-entered radius shows.

Leave a Reply

Your email address will not be published. Required fields are marked *