Home / Autodesk Inventor Help / Constraint Settings dialog box – Relax Mode tab

Constraint Settings dialog box – Relax Mode tab

Access

Ribbon: Sketch tab  Constrain Panel  Constraint Settings: Relax Mode tab 

 OptionsSketch tab: Constraint Settings: Relax Mode tab

Enable Relax Mode

Sets the default behavior for Relax Mode.

NOTE:You can also toggle Relax Mode On and Off from the status bar  or by pressing F11 in the 2D sketch environment.

For more information refer to Relax Mode

Constraints to remove in relax dragging

Lists the constraint glyphs to show or hide.

Select All
Places a check mark in each active check box.

Clear All
Removes all check marks. No constraint glyphs are shown.

The following lists the constraint types and their definitions:hr1 hr2 hr3

Leave a Reply

Your email address will not be published. Required fields are marked *