Home / Cimatron Help / Cimatron E10 Tooling tips

Cimatron E10 Tooling tips

cimatron e10
cimatron e10

The version 10 control panel has a Catalog Location utility. The path set here should be where your current catalog parts reside. Cimatron parts will retain a link to the catalog table they were created from. However, this link may not work properly when opening an older job or a job
from another site. Rather than ask for a manual reconnect, the E10 system will look for catalogs in the folder specified in the Catalog Location utility. If the catalogs are not found at this location either, a reconnect will be required.
Version 10 allows the center of a cylindrical face or the direction of a coordinate system to be selected as an when using Move/Rotate or Revolve. This saves the time and effort of defining mostdatum axis as entities.



Incoming search terms:

  • kjujnbgs dct[ dthcbq сшьфекщт

Leave a Reply

Your email address will not be published. Required fields are marked *