Use the fourth page of the Last Identification Wizard to adjust the alignment of the last. The original alignment of the last is displayed as wireframe. Entering new values or using the sliders to make adjustments, modifies the model.
- Use the slider to Swivel the last across its length, as shown by the green arrow on the dialog. Alternatively, enter an angle of rotation in the box.
- Use the slider to adjust the Toe Spring, as shown by the blue arrow on the dialog . Alternatively, enter a value in the box. If you use the slider, the value in the box will change automatically.
- Use the slider to adjust the Heel Height, represented by the red arrow on the dialog. Alternatively, enter a height in the box. If you use the slider, the value in the box will change automatically.
- Adjusting the Toe Spring will result in a change to the Heel Height. Similarly, adjusting the Heel Height will affect the Toe Spring.
- Click one of the following buttons:
- Back to select Points on the last.
- Next to specify the Attributes of the last.
- Finish to create the last.
Cancel to finish the Last Identification Wizard without making any changes
